Furnace Repair You Can Count On in Bradford, OH

A dirty air filter restricts airflow and often causes a furnace to blow cold air. Turn the system off, replace the filter with the correct size, and wait 30 minutes before restarting. Check that the thermostat is set to heat mode and the temperature is higher than room temperature. In Bradford, OH winters, a clogged filter can lead to frozen coils if ignored. If the problem continues after the filter change, the issue may involve the blower motor or limit switch.

A weak thermocouple or drafts around the burner compartment usually cause the pilot to extinguish. First, ensure the furnace door is fully closed and the area around the unit is free of strong air currents. If the pilot still will not stay lit after relighting per the label instructions, turn the gas valve off and do not attempt further adjustments.

A burning smell on first startup in fall is often dust burning off the heat exchanger and may clear after a few hours. Persistent or strong odors can indicate overheating or electrical issues. Turn the thermostat down, switch power off at the breaker, and call (321) 463-9811. Do not keep running the unit in Bradford, OH winter conditions if the smell returns.

A sealed air conditioning system does not use refrigerant up, so if the charge is low there is a leak somewhere. Cooling that weakens season after season, ice on the line set, or a hissing sound near the indoor unit all point to a leak rather than normal top-up. Adding refrigerant without locating the leak means paying again next season, and running low charge makes the compressor run hot. Ask for the leak to be found and quoted before agreeing to a recharge in Bradford, OH.

Yes, and it is the most common cause of faults that look like equipment failure. A restricted filter makes a furnace overheat and shut down on its limit switch, freezes an air conditioning evaporator coil solid, and makes the blower motor draw high current until it fails early. Two things matter more than brand: the filter must fit its slot tightly, because a loose filter lets air bypass it completely, and a very high MERV rating in a system not designed for it restricts airflow enough to cause the same overheating it was meant to prevent. A filter that darkens within weeks in Bradford, OH usually means duct leakage is pulling in unfiltered air.